EPOSEALER IMPREGNAZIONE & ANTIOSMOSI

EPOSEALER IMPREGNAZIONE & ANTIOSMOSI

It is a solvent free liquid epoxy resin, activated with a cyclo-aliphatic amine, with high insulation and adhesion power. Thanks to its characteristics of penetration, adhesion, flexibility and water resistance performs a waterproof film on the wood surface while maintaining its natural properties. It is therefore the most suitable product for the treatment and maintenance of wood. Provides also outstanding anti-osmosis properties when used on fiberglass boats.

Brand : SKIPPER'S LINE MARINE PAINTS
Description

SURFACE PREPARATION AND APPLICATION PROCEDURE


FOR IMPREGNATION PURPOSE. Clean, degrease and sandpaper the wooden surfaces to be coated. Make sure the wood is dry and then apply 3-4 coats of EPOSEALER IMPREGNAZIONE & ANTIOSMOSI allowing 12-24 hours between coats, achieving a final thickness of 300 dry micros. Within 24 hours from the last coat of EPOSEALER IMPREGNAZIONE & ANTIOSMOSIS overcoat with one coat of UNIFIBER PRIMER. The product can be applied by roller or brush


FOR ANTIOSMOSIS PURPOSE. For the treatment of boat bottoms affected by osmosis, remove first the jelcoat layer completely; remove (preferably by sndblasting) all bubbles of osmosis by fully opening their craters. Rinse accurately with fresh water, use hot water if possible. Before starting procedure make sure that the bottom is perfectly dry. Apply one coat of EPOSEALER IMPREGNAZIONE & ANTIOSMOSI on the parts affected by osmosis. Within 24 hours level all craters with one coat of EPOXY LIGHT FILLER NS until a smooth surfacace is achieved with several coats of fillers; sand between coats. Use PLAMUR FINISHER for fillerr finishing. Apply then 3-4 coats of EPOSEALER IMPREGNAZIONE & ANTIOSMOSI (allowing 12-24 hours between coats) to build up a total thickness of 600 mcirons. 

Within 24 hours from the last coat of EPOSEALER IMPREGNAZIONE E ANTIOSMOSi overcoat with one coat of UNIFIBER PRIMER. The product can be applied by roller or brush. The application with a short bristless type of roller is recommended.

Product Specification
RESINS & GELCOAT
EPOSEALER IMPREGNAZIONE & ANTIOSMOSI
Paint Type
Two components
Specific gravity kg/lt (±0,05)
1,130 (A) - 0,970 (B)
Viscosity Ford Ø4
12 seconds
Mixing ratio A+B by volume
2 parts of Sol.A with 1 of Sol.B
Temperature Pot Life
20°c
Dust dry
n,d
Application temperature
Between +10 C and +40 C
Dry film thickness advised
100 microns per coat
Colors
NEUTRO
Binder type A
Liquid epoxy resin
Shelf life (+10+30°C)
12 months in airtight cans
Application
Brush-Roller
Pot life A+B (20°C)
Use mixture within 30-50 minutes
Brush-Roller
Ready to use. When used as a primer on bare wood: dilute 40-50% with Thinner 765
Recoat time
24 h (20°c)
Relevant humidity
Less than 80%
Theoret. coverage m2/Lt
5
Color code
G4420