POLIMAT

POLIMAT

Two-component, polyurethane clear matt varnish widely used for the application on interior of boats, furniture, frames etc. where a matt finish is desired. Gives a non reflecting, tough film enhancing the warm characharacteristic of wood.
Brand : SKIPPER'S LINE MARINE PAINTS
Description
SURFACE PREPARATION AND APPLICATION PROCEDURE - Bare Wood. - In order to obtain “closed-pore” smooth surface, apply two coats of POLIGLASS varnish diluted up to 50-100% (according to wood absorption). If the pores on the wood is coarse, a third coat, less diluted, may be required. Let dry for 8-12 hours, rub down with fine abrasive-paper and apply 2-3 coats of POLIMAT varnish allowing the recommended waiting time between coats. - On the other hand, if a surface with “open-pore” is desired, apply a single coat of POLIGLASS thinned 50-100%, (according wood absorption). Let dry for 8-12 hours, rub down with fine abrasive-paper and apply 2-3 coats of POLIMAT varnish allowing the recommended waiting time between coats. Previously Varnished Wood - Test a small patch of the coated surface to verify if POLIGLASS is compatible with the old varnish and to make sure that the old coating is still in sound condition. - If the old coating is in good condition and compatible, sandpaper and overcoat with 2-3 coats of POLIGLASS varnish allowing 8-12 hours between coats. Apply then 2-3 coats of POLIMAT varnish allowing the recommended waiting time between coats. - In the case of loose, powdery or non-compatible old varnish, it is recommended that the old varnish should be stripped completely down to bare wood with a paint-remover or by scraping and sandpapering. Then follow the application directions as suggested for bare wood.
Product Specification
VARNISHES
POLIMAT
Paint Type
Two components
Binder type B
Isocyanates
Code & colour B
8ZMAT
Solids content (volume) ±2
24%
Shelf life (+10+30°C)
12 months in airtight cans
Application
Brush-Roller-Spray
Pot life A+B (20°C)
use within 6-8 hours
Spray
10-20% Thinner 203
Recoat time
8-12 h (20°c)
Relevant humidity
Less than 80%
Theoret. coverage m2/Lt
8
Color code
5Z0000
Binder type A
Poliurethane
Code & colour A
5Z0000
Specific gravity kg/lt (±0,05)
1.005 (A) - 1.030 (B)
Viscosity Ford ø 8 at 20°C ±2
20-25 sec. (Ø4 a 20°C)
Viscosity Ford Ø4
20-25 sec. (20°C)
Mixing ratio A+B by volume
2 parts Sol.A with 1 Sol.B
Brush-Roller
5-10% Thinner 205
Dust dry
15-20 minutes (20c)
Application temperature
Between +10 C and +40 C
Dry film thickness advised
40 microns per coat
Colors
TRASPARENTE