POLIFOND

POLIFOND

Two-component polyurethane white undercoat for boats and applications in the automotive field, with excellent coverage and good filling power. Used as an intermediate coat on wood, steel or fibreglass surfaces or as a pre-treatment primer before overcoating with two-component enamels (e.g. Acriglass, Space Top or Whitext).
Brand : SKIPPER'S LINE MARINE PAINTS
Description
SURFACE PREPARATION AND APPLICATION PROCEDURE - Bare Steel - Sandblasting according to SA 2,5 or, if not possible, adequate mechanical cleaning should be carried out onto bare steel surfaces. Apply 1 coat of epoxy primer (e.g. EPOZINC 2C or EPOFOND AM-9) and let dry as suggested. Apply 1-2 coats of POLIFOND and overcoat with the recommended topcoat allowing the required waiting period between coats. Previously Coated Steel - If the existing paint is polyurethane or epoxy based, sandpaper and apply 1-2 coats of POLIFOND and overcoat with the required finish. In case of doubt on the nature of the old paint, sandpaper and carry our a patch test in order to ensure that the surface would not be softened or lift off when POLIFOND is being applied over. If this would happen remove all the old paint down to bare steel and follow the directions as per Bare Steel. Bare Wood - Apply one coat of POLIGLASS varnish thinned up to 50-100% with Thinner 203 or as alternative one coat of CROMOMINIO diluted 30-40% with Thinner 107. Let dry for 8-12 hours and after sanding apply 1-2 coats of POLIFOND followed with the recommended topcoat allowing the required waiting period between coats. Previously Coated Wood - If the old paint was epoxy or polyurethane based and in good condition, sandpaper and apply 1-2 coats of POLIFOND and overcoat with the desired topcoat allowing the required waiting period between coats. On the other hand, if unknown or in poor condition, it is advisable to remove it down to bare wood and proceed as recommended for Bare Wood.
Product Specification
PRIMERS & UNDERCOATS
POLIFOND
Paint Type
Two components
Binder type B
Isocyanates
Solids content (volume) ±2
43%
Viscosity Ford Ø4
120-150 sec. (A+B)
Mixing ratio A+B by volume
5 Part. Sol A with 2 Part. Sol. B
Brush-Roller
15-30%Diluent 205
Touch dry
3-4 h (20°c)
Application temperature
Between +10 C and +40 C
Dry film thickness advised
35-40 microns per coat
Colors
BIANCO
Binder type A
Polyester
Specific gravity kg/lt (±0,05)
1.640 (A) - 1.000 (B)
Shelf life (+10+30°C)
12 months in airtight cans
Application
Brush-Roller-Spray
Pot life A+B (20°C)
use within 6-8 hours
Spray
25-35% Diluent 203
Recoat time
12-24 h (20°c)
Relevant humidity
Less than 80%
Theoret. coverage m2/Lt
14-15
Color code
5S0000