UNIFIBER PRIMER

UNIFIBER PRIMER

One-component primer for low thickness direct application onto fibreglass boat bottoms. Also recommended as a primer coat before antifouling application and as a tie-coat between epoxy or polyurethane two-component paints and one-component finishes. Overcoatable with TOPKAPI enamel for topside and superstructure finish or with appropriate antifouling paint for boat bottom finish.
Brand : SKIPPER'S LINE MARINE PAINTS
Description
SURFACE PREPARATION AND APPLICATION PROCEDURE - Bare Fibreglass - The surface to be coated should be perfectly cleaned, degreased with suitable detergent solution, rinsed with water and slightly sandpapered with fine abrasive paper. Remove dust particles from the surface. Apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. After 24 hours apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom) and let dry as recommended. After 6-8 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom. Previously Coated Fibreglass with 2-component paint - The pre-existing paint should be in good condition of adhesion to the substrate. Sandpaper and apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. After 24 hours sandpaper and apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom). After 24 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom.
Product Specification
PRIMERS & UNDERCOATS
UNIFIBER PRIMER
Paint Type
One component
Specific gravity kg/lt (±0,05)
1.180
Viscosity Ford ø 8 at 20°C ±2
50''
Application
Brush-Roller-Spray
Spray
10-20% Thinner 765
Recoat time
Minimum 6 h (20°c)
Relevant humidity
Less than 80%
Theoret. coverage m2/Lt
10
Color code
4S4705
Binder type A
Vynil modified
Solids content (volume) ±2
24%
Shelf life (+10+30°C)
18 months in airtight cans
Brush-Roller
0-5% Thinner 765
Touch dry
20-30 minutes (20°C)
Application temperature
Between +10 C and +40 C
Dry film thickness advised
15 microns per coat
Colors
VERDE